Changing tires on a Chrysler is a simple process that can be done with minimal tools and experience. Here are the steps to follow:

1. Find a safe location: Before beginning the tire change, make sure the Chrysler is parked on a level surface away from traffic. Turn on the hazard lights and engage the emergency brake.

2. Gather tools: You will need a lug wrench, a jack, and a spare tire. These tools are usually located in the trunk of the Chrysler.

3. Loosen the lug nuts: Use the lug wrench to loosen the lug nuts on the tire you want to change. Turn the wrench counterclockwise to loosen the nuts. Do not remove the lug nuts yet.

4. Position the jack: Locate the jacking point on the Chrysler. This is usually indicated by a notch or a raised area on the underside of the car. Place the jack under the jacking point and raise the car until the tire is off the ground.

5. Remove the lug nuts: Use the lug wrench to remove the lug nuts completely. Set them aside in a safe place.

6. Remove the tire: Pull the tire off the hub and set it aside.

7. Install the spare tire: Place the spare tire on the hub and align the holes with the studs. Push the tire onto the hub until it is flush with the hub.

8. Tighten the lug nuts: Use the lug wrench to tighten the lug nuts in a star pattern. This will ensure that the tire is properly secured.

9. Lower the car: Use the jack to lower the Chrysler back to the ground.

10. Tighten the lug nuts again: Use the lug wrench to tighten the lug nuts once more in a star pattern.

11. Check the tire pressure: Use a tire pressure gauge to check the pressure of the spare tire. Inflate it to the recommended pressure if necessary.

12. Store the old tire: Place the old tire in the trunk of the Chrysler.

In conclusion, changing tires on a Chrysler is a straightforward process that can be done with minimal tools and experience. Always make sure to follow safety procedures and check the tire pressure before driving on the spare tire.